South African Class ME 2-6-6-2

The South African Railways Class ME 2-6-6-2 of 1912 was a steam locomotive.

South African Class ME 2-6-6-2
Class ME no. 1618, c. 1912
Type and origin
Power typeSteam
DesignerNorth British Locomotive Company
BuilderNorth British Locomotive Company
Serial number19355
ModelCSAR Mallet
Build date1912
Total produced1
Specifications
Configuration:
 • Whyte2-6-6-2 (Prairie Mallet)
 • UIC(1'C)C1'h4
Driver3rd & 6th coupled axles
Gauge3 ft 6 in (1,067 mm) Cape gauge
Leading dia.30 in (762 mm)
Coupled dia.42+14 in (1,073 mm)
Trailing dia.30 in (762 mm)
Tender wheels34 in (864 mm)
Wheelbase58 ft 5+12 in (17,818 mm) ​
 • Engine38 ft 3 in (11,659 mm)
 • Coupled8 ft 6 in (2,591 mm) per unit
 • Tender14 ft 7 in (4,445 mm)
 • Tender bogie4 ft 7 in (1,397 mm)
Length:
 • Over couplers66 ft 7+38 in (20,304 mm)
Height12 ft 10 in (3,912 mm)
Frame typePlate
Axle load9 LT 18 cwt (10,060 kg) ​
 • Leading6 LT (6,096 kg)
 • Coupled9 LT 18 cwt (10,060 kg)
 • Trailing6 LT 14 cwt (6,808 kg)
 • Tender bogieBogie 1: 18 LT 4 cwt (18,490 kg)
Bogie 2: 19 LT 8 cwt (19,710 kg)
 • Tender axle9 LT 14 cwt (9,856 kg)
Adhesive weight59 LT 8 cwt (60,350 kg)
Loco weight72 LT 2 cwt (73,260 kg)
Tender weight37 LT 12 cwt (38,200 kg)
Total weight109 LT 14 cwt (111,500 kg)
Tender typeXF (2-axle bogies)
Fuel typeCoal
Fuel capacity6 LT (6.1 t)
Water cap.3,000 imp gal (13,600 L)
Firebox:
 • TypeBelpaire
 • Grate area32 sq ft (3.0 m2)
Boiler:
 • Pitch7 ft 9 in (2,362 mm)
 • Diameter4 ft 1+34 in (1,264 mm)
 • Tube plates18 ft 6+12 in (5,652 mm)
 • Small tubes90: 2+14 in (57 mm)
 • Large tubes14: 5+14 in (133 mm)
Boiler pressure170 psi (1,172 kPa)
Safety valveRamsbottom
Heating surface:
 • Firebox115 sq ft (10.7 m2)
 • Tubes1,340 sq ft (124 m2)
 • Total surface1,455 sq ft (135.2 m2)
Superheater:
 • TypeSchmidt
 • Heating area346 sq ft (32.1 m2)
CylindersFour
Cylinder size15 in (381 mm) bore
23 in (584 mm) stroke
Valve gearWalschaerts
Valve typePiston
CouplersJohnston link-and-pin
Performance figures
Tractive effort31,230 lbf (138.9 kN) @ 50%
Career
OperatorsSouth African Railways
ClassClass ME
Number in class1
Numbers1618
Delivered1912
First run1912
Withdrawn1937

In January 1912, the South African Railways placed a single Class ME Mallet articulated steam locomotive with a 2-6-6-2 wheel arrangement in service.[1][2][3][4]

Manufacturer

edit

During 1911, the Central South African Railways (CSAR) placed an order for a single experimental simple expansion Mallet articulated steam locomotive with the North British Locomotive Company (NBL). The locomotive was intended for test purposes on branch lines with light 45 pounds per yard (22 kilograms per metre) rail.[1][2][3][5]

By the time it was delivered in January 1912, the CSAR had already become part of the newly established South African Railways (SAR). The locomotive was therefore classified as the sole Class ME and numbered 1618 on the SAR roster.[1][2][3][4]

Characteristics

edit

Having been built for branch line working, the engine's maximum axle load was 9 long tons 18 hundredweight (10,060 kilograms) and it was delivered with the 6 long tons (6.1 tonnes) coal capacity version of the Type XF tender. Its Belpaire firebox extended over the second and third coupled wheels of the rear engine unit.[2][6][7]

Compared to other Mallet locomotives which were placed in service during the first decade of the SAR’s existence, the Class ME was unique in being arranged as a simple expansion (simplex) locomotive with four high-pressure cylinders instead of the more usual compound expansion arrangement of two high-pressure and two low-pressure cylinders.[1][3][8]

The cylinders were arranged outside the plate frames and the 6 inches (152 millimetres) diameter trick-ported piston valves, designed for inside admission, were actuated by Walschaerts valve gear. Each engine unit was equipped with an independent Wakefield mechanical lubricator to supply oil to the valves and pistons.[2]

The comparatively low boiler pressure of 170 pounds per square inch (1,172 kilopascals) is indicative of the opinion held at the time that the economies to be gained from superheating did not require high boiler pressure. The boiler was equipped with a Schmidt superheater. Steam distribution to the four cylinders was rather unique, being led from the superheater header in the smokebox to a steam collector box which was arranged between the two cylinders of the rear engine unit, from where a branch was led to the cylinders of the front engine unit by a central steam pipe with flexible joints, since this engine unit could move sideways in relation to the boiler barrel. This pipe took the place of the usual receiver pipe on compound Mallets.[2]

The blast pipe had separate outlets for the exhaust steam from each engine unit, with the rear engine unit's exhaust feeding through an annulus arranged around the exhaust from the front engine unit. A device was installed by which either engine unit could be cut out whilst running so that steam could be admitted to one pair of cylinders only when running light engine.[2]

Service

edit

The Class ME proved to be successful in operation and, even though it was acquired as an experimental locomotive, remained in service for 25 years. It spent its last years working on the line from Nelspruit to Sabie in the Eastern Transvaal Lowveld, until it was withdrawn and scrapped in 1937.[1]

Illustration

edit

References

edit
  1. ^ a b c d e Holland, D. F. (1972). Steam Locomotives of the South African Railways. Vol. 2: 1910-1955 (1st ed.). Newton Abbott, England: David & Charles. pp. 21–22. ISBN 978-0-7153-5427-8.
  2. ^ a b c d e f g Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, May 1945. pp. 347-348.
  3. ^ a b c d Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 86. ISBN 0869772112.
  4. ^ a b Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer’s Office, Pretoria, January 1912, pp. 9, 12, 15, 46 (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
  5. ^ North British Locomotive Company works list, compiled by Austrian locomotive historian Bernhard Schmeiser
  6. ^ South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 3'6" Gauge/Spoorwydte. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. p. 43.
  7. ^ South African Railways & Harbours/Suid Afrikaanse Spoorweë en Hawens (15 Aug 1941). Locomotive Diagram Book/Lokomotiefdiagramboek, 2'0" & 3'6" Gauge/Spoorwydte, Steam Locomotives/Stoomlokomotiewe. SAR/SAS Mechanical Department/Werktuigkundige Dept. Drawing Office/Tekenkantoor, Pretoria. pp. 6a-7a, 41, 43.
  8. ^ Holland, D.F. (1971). Steam Locomotives of the South African Railways. Vol. 1: 1859–1910 (1st ed.). Newton Abbott, England: David & Charles. pp. 54, 56. ISBN 978-0-7153-5382-0.