Reedmergnerite is a borosilicate mineral named in honor of Frank S. Reed and John L. Mergner. It is approved by the International Mineralogical Association but was first described prior to the association's formation, first published in 1955. Although it is approved, it got grandfathered, meaning the name reedmergnerite is still believed to refer to a valid species. Reedmergnerite has a synthetic potassium analogue.[2]

Reedmergnerite
General
CategoryMineral
Formula
(repeating unit)
NaBSi3O8
IMA symbolRm[1]
Strunz classification9.FA.35
Dana classification76.1.4.1
Crystal systemTriclinic
Crystal classPinacoidal
H-M Symbol: 1
Space groupC1
Unit cell587.34
Identification
Formula mass246.05
ColorColorless to yellow-orange, salmon-orange
CleavagePerfect on {001}
Mohs scale hardness6 – 6.5
LusterVitreous
StreakWhite
DiaphaneityTransparent, translucent
Density2.776
Optical propertiesBiaxial (−)
Refractive indexnα = 1.554
nβ = 1.565
nγ = 1.573
Birefringence0.019
2V angle80°
DispersionNone
Common impuritiesTi, Al, Fe, Mg, Ca, Ba, K, F, H2O, P

Properties

edit

Reedmergnerite is a member of the feldspar group.[2] It grows along bedding laminations as authigenic crystals, as a stubby prismatic to platy crystals. It is wedge-shaped usually, and it may have jagged terminations. Crystals grow in aggregates, and a singular crystal's size can reach up to 10 cm.[3] It is isostructural with low albite. It does not exhibit anisotropy.[4] The mineral has been synthesized using gels. The procedure occurred hydrothermally. The gels that were used in the synthesis contained a 10% weight excess of silicon dioxide. While the pressure and the temperature were constant, the degree of boron and silicon order increased with time, though both lower water content and pressure decrease the rate of ordering. The mineral's ordering behavior occurs to be insensitive to the co-existing fluid's composition.

Environment and mining

edit

Although it has three type localities,[3] the most important of those is at Joseph Smith No. 1 well in the United States. The associated minerals at the type locality are eitelite, searlesite, crocidolite, leucosphenite and shortite. It happens to occur in dolomitic shale mostly.[2] However, it can also occur in brown dolomitic rock and black oil shale as well.

References

edit
  1. ^ Warr, L.N. (2021). "IMA–CNMNC approved mineral symbols". Mineralogical Magazine. 85 (3): 291–320. Bibcode:2021MinM...85..291W. doi:10.1180/mgm.2021.43. S2CID 235729616.
  2. ^ a b c "Reedmergnerite". www.mindat.org. Retrieved 2021-10-14.
  3. ^ a b "Reedmergnerite" (PDF). Handbook of Mineralogy.
  4. ^ Appleman, Daniel E.; Clark, Joan R. (1965-12-01). "Crystal structure of reedmergnerite, a boron albite, and its relation to feldspar crystal chemistry1". American Mineralogist. 50 (11–12): 1827–1850. ISSN 0003-004X.