The FSC Lublin-51 is a Polish small-capacity truck that was a licensed version of the Soviet GAZ-51. Production began on 7 November 1951 and ended in June 1959. The model was replaced by the Polish developed FSC Żuk delivery vehicle. A total of 17,479 examples of the FSC Lublin-51 were produced.

FSC Lublin-51
Overview
ManufacturerFSC
Production7 November 1951 – June 1959
AssemblyPoland, Lublin
Body and chassis
Body styleTruck
RelatedGAZ-51, Star 20
Powertrain
EngineM-51, petrol, in-line, 6-cylinder, 51.5 kW (70HP)[1]
Transmission4-speed, manual, unsynchronised
Dimensions
Wheelbase3310mm
Length5525mm[1]
Width2200mm[1]
Height2130mm[1]
Chronology
SuccessorFSC Żuk

History

edit
 
FSC Lublin-51 ambulance
 
FSC Lublin-51 in 1990

In December 1948, a decision was made to begin production of trucks under the license of the Soviet GAZ-51 model in the pre-war Lilpop, Rau i Loewenstein plants in Lublin. The agreement with the Soviets was signed on 22 July 1950. According to initial assumptions, the plant's annual production was to be approximately 12,000 copies, but at the end of 1950 the production capacity was increased to 25,000 pieces per year. The first copy of this car was assembled on November 7, 1951, from parts supplied by the licensor.[citation needed]

The body of Lublin-51 was mounted on a longitudinal, riveted frame made of pressed sheet metal. The suspension system used a front rigid axle suspended on semi-elliptical leaf springs and two hydraulic arm shock absorbers. At the rear, the drive axle was suspended on semi-elliptical leaf springs, additionally supported by auxiliary leaf springs. This vehicle used a steering gear with a globoid worm. It is powered by an imported 6-cylinder in-line M-51 petrol engine with a capacity of 3,480 cm³ and a maximum power of 51.5 kW (70 HP). This unit is mated to a 4-speed manual, non-synchronised gearbox. The Lublin-51 was equipped with a cabin with the engine extended. The cabin frame is made of wood and covered with waterproof plywood. The side panels, engine hood and fenders were made of steel sheet, while the roof was covered with dermatoid.[citation needed]

Modernizations were carried out during production. A new type of carburetor with a vacuum-controlled saver was used, the vacuum wiper drive system was replaced with electric motors and a fully metal cabin was put into production.[citation needed]

Despite the modernization, it was not possible to eliminate the basic drawbacks of this vehicle: too low load capacity for a truck and high fuel consumption. Production ended in June 1959, after 17,479 units had been produced.[citation needed]

Various versions of bodies were mounted on the chassis of the FSC Lublin-51 model, such as a cargo box, van bodies produced by Zakłady Budowy Adżużu Samochodowych in Nysa, bodies for traveling cinemas, repair workshops and sanitary bodies type N-243, produced by Zakłady Budowy Adżużu Samochodowych in Nysa (Jelcz).[citation needed]

Technical data

edit
Engine type R6 lower valve, four-stroke M-51[1]
Number of cylinders 6
Displacement 3,480 cm3 (212 cu in)
Power 70 HP (51.5 kW) at 2800 rpm
Max torque at rpm 200 N⋅m (150 lbf⋅ft) at 1500 rpm
Max speed 70 km/h (43 mph)[1]
Fuel consumption per 100 km 26 l[1]
Compression ratio 6.2[1]
Transmission 4-speed manual
Curb weight 2,710 kg (5,970 lb)
Permissible gross weight 5,350 kg (11,790 lb)
Tire size 7.50-20"[1]
Brakes Drum, hydraulic, single-circuit on all wheels
Cylinder diameter 82 mm (3.2 in)
Piston stroke 110 mm (4.3 in)
Wheelbase 1,400 mm (55 in)[1]
Capacity 2.5 t (2.5 long tons; 2.8 short tons)[1]

References

edit
  1. ^ a b c d e f g h i j k "GAZ 51 / Lublin 51". Archived from the original on 24 May 2009. Retrieved 2 April 2010.

Bibliography

edit
edit