Caldie is a chromium-molybdenum-vanadium alloyed tool steel manufactured by Uddeholms AB. It is intended for cold work processes, such as blanking and piercing, applied to difficult materials such as advanced high strength steel, where compressive strength and chipping and cracking resistance are important.

Composition

edit

The steel's composition is[1]

C Si Mn Cr Mo Ni V S
0.7 0.2 0.5 5.0 2.3 - 0.5 -

Properties

edit

Uddeholm Caldie is characterized by:[2]

  • Very good chipping and cracking resistance
  • Good wear resistance
  • High hardness (>60 HRC) after high temperature tempering
  • Good dimensional stability in heat treatment and in service
  • Excellent through-hardening properties
  • Good machinability and grindability
  • Excellent polishability
  • Good surface treatment properties
  • Good resistance to tempering back
  • Very good WEDM properties

Application areas

edit

Uddeholm Caldie is suitable for short to medium run tooling where chipping and/or cracking are the predominant failure mechanisms and where a high compressive strength (hardness of over 60 HRC) is necessary. This makes Uddeholm Caldie very suitable for severe cold work applications where the combination of a hardness above 60 HRC and a high cracking resistance is of utmost importance e.g. as in the blanking and forming of ultra high strength steel sheets. Uddeholm Caldie is also very suitable as a substrate steel for applications where surface coatings are desirable or necessary.

This steel can be used in engineering applications where high compressive strength has to be combined with high ductility/toughness. Knives for fragmentation of plastics and metals and roll forming rolls are good examples

See also

edit

References

edit
  1. ^ Pocket Book: The Uddeholm range of tooling materials, Third Edition, 03.2011
  2. ^ Uddeholm Caldie, Seventh Edition, 01.2010