Vertical position

(Redirected from Vertical separation)

Vertical position or vertical location is a position along a vertical direction (the plumb line direction) above or below a given vertical datum (a reference level surface, such as mean sea level). Vertical distance or vertical separation is the distance between two vertical positions. Many vertical coordinates exist for expressing vertical position: depth, height, altitude, elevation, etc. Points lying on an equigeopotential surface are said to be on the same vertical level, as in a water level.

Definitions

edit

The International Organization for Standardization (ISO), more specifically ISO 19111, offers the following two definitions:[1]

  • depth: "distance of a point from a chosen reference surface measured downward along a line perpendicular to that surface."[1]
  • height: "distance of a point from a chosen reference surface measured upward along a line perpendicular to that surface";[1]

ISO 6709 (2008 version) makes the following additional definition:

  • altitude: "height where the chosen reference surface is mean sea level"[1]

The International Civil Aviation Organization (ICAO) offers similar definitions:[2]

  • altitude: "the vertical distance of a level, a point or an object considered as a point, measured from the mean sea level (MSL);"[2]
  • height: "the vertical distance of a level, a point or an object considered as a point, measured from a specific datum."[2]

ICAO further defines:

  • elevation: "the vertical distance of a point or a level, on or affixed to the surface of the earth, measured from mean sea level."[2]

I.e., elevation would be the altitude of the ground or a building.

Derived quantities

edit

Several physical quantities may be defined based on the definitions above:

Units

edit

Vertical distance quantities, such as orthometric height, may be expressed in various units: metres, feet, etc.

Certain vertical coordinates are not based on length, for example, geopotential numbers have units of m2/s2. Normalization by a constant nominal gravity value (units of m/s2) yields units of metre, as in geopotential height (based on standard gravity) or dynamic height (based on normal gravity at 45 degrees latitude). Despite the physical dimension and unit of length, the vertical coordinate does not represent distance in physical space, as would be measured with a ruler or tape measure. Sometimes a geopotential metre (symbol gpm or m') or dynamic metre is introduced for emphasis.[3][4] However, this practice is not acceptable with the International System of Units (SI).[a]

Another non-SI unit is the vertical metre, introduced when there may be confusion between vertical, horizontal, or slant distances. It is used for distance climbed during sports such as mountaineering, skiing, hiking, running or cycling[6] In German-speaking countries the abbreviation 'Hm' for Höhenmeter ("height metre") is used; if it is preceded by a '±' it refers to the cumulative elevation gain.

Determination

edit

Various instruments and techniques may be used for measuring or determining vertical position:

Phenomena

edit

Many physical phenomena are related to vertical position, as driven by gravity:

See also

edit

Notes

edit
  1. ^ The Guide for the Use of the International System of Units, section 7.5 (Unacceptability of mixing information with units), states:[5]

    When one gives the value of a quantity, any information concerning the quantity or its conditions of measurement must be presented in such a way as not to be associated with the unit.

References

edit
  1. ^ a b c d "ISO 6709:2008(en) preview". www.iso.org. ISO. Retrieved 8 June 2016.
  2. ^ a b c d United Nations - International Civil Aviation Organization. "Annex 4: Aeronautical Charts - Chapter 1 (Definitions, Applicability and Availability)" (PDF). Archived from the original (PDF) on 2016-09-17. Note: Annex 4 is one of the (currently) 19 annexes to the Chicago Convention on International Civil Aviation (ICAO Doc. 7300).
  3. ^ World Meteorological Organization - Guide to Meteorological Instruments and Methods of Observation - Preliminary seventh edition - WMO-No. 8 - Secretariat of the World Meteorological Organization – Geneva – Switzerland - 2006
  4. ^ Bjerknes, V. (1910). Dynamic Meteorology and Hydrography: Part [1]-2, [and atlas of plates]. Carnegie Institution of Washington publication. Carnegie Institution of Washington. p. 13. Retrieved 2023-10-05.
  5. ^ Thompson, Ambler; Taylor, Barry N. (2018-11-10). "Guide for the Use of the International System of Units (SI)". NIST. Retrieved 2020-12-09.
  6. ^ Nash, Mike, Exploring Prince George: A Guide to North Central B. C. Outdoors, Vancouver: Rocky Mountain Books, 2004, p. 105.

Further reading

edit
edit