UA120 was a family of American solid rocket boosters, manufactured by the Chemical Systems Division of United Aircraft (later United Technologies Corporation).[1] They were used as strap-on boosters for the Titan rocket family.[2] Several variants existed, with a varying number of segments.

Launch of a Titan 34D with two UA1206 boosters

Design

edit
 
Schematic of the UA1205 and UA1207 boosters

All versions of UA120 shared a common design, with the only significant differentiating factor being the length of the motor. It was a segmented design, with between five and seven motor segments possible. A solid propellant used was a ammonium perchlorate composite propellant with polybutadiene acrylonitrile (PBAN) binder.[3] The stage had an external diameter of 120 inches.[4] Attitude control in flight was provided by means of a liquid injection thrust vector control (LITVC) system, with an external nacelle containing nitrogen tetroxide attached to the side of each booster.[4] Solid fueled separation rockets, used to jettison the spent boosters, were affixed at the top and bottom of the stage.[4] Thrust-termination capability, necessary for crewed rockets such as the Space Shuttle or Manned Orbiting Laboratory, was to be provided by two pyrotechnically triggered ports on the forward closure, which when opened would allow for the non-propulsive venting of exhaust gasses.[5] The forward end of the stage contained an aerodynamic nose cone, an ignitor, separation rockets, and the forward attachment ring. The aft end contained additional separation rockets, the nozzle, and a heat shield.[4]

Variants

edit

The overall design of each variant was very similar, the main difference being the number of segments used. This is indicated by the number at the end of each designation.

UA1205

edit

UA1205 was flown between 1982 and 1992,[3] and used as a strap-on booster on the Titan IIIC, Titan 23C, Titan IIID, and Titan IIIE rockets, besides being proposed for use on several derivatives of the Saturn rocket family.[3][4][2]

UA1206

edit

The UA1206 was flown between 1982 and 1992,[6] and used as a strap-on booster on Titan 34D and Commercial Titan III.[7][2]

UA1207

edit

UA1207 was first flown in 1989 and used on Titan IV-A.[8][2] It was proposed for several other variants of Titan III and IV, as well as the Titan-IIIM, derivatives of the Saturn rocket family and the Space Shuttle.[4][5][8]

See also

edit

References

edit
  1. ^ "UA1200". www.astronautix.com. Retrieved 2024-10-05.
  2. ^ a b c d "Titan Family". Gunter's Space Page. Retrieved 2024-10-05.
  3. ^ a b c "UA1205". Astronautix. Archived from the original on March 1, 2002. Retrieved 26 February 2016.
  4. ^ a b c d e f "A STUDY OF PERFORMANCE AND COST IMPROVEMENT POTENTIAL OF THE 120-IN.- (3.05 M) DIAMETER SOLID ROCKET MOTOR" (PDF). United Aircraft Corporation. December 1971. Retrieved 26 February 2016.
  5. ^ a b "Study of Solid Rocket Motors for a Space Shuttle Booster" (PDF). United Technology Center. 15 March 1972. Retrieved 26 February 2016.
  6. ^ "UA1206". 2002-02-08. Archived from the original on 2002-02-08. Retrieved 2024-10-05.
  7. ^ "Titan UA1206". Astronautix. Archived from the original on February 8, 2002. Retrieved 26 February 2016.
  8. ^ a b "UA1207". Astronautix. Archived from the original on 4 March 2016. Retrieved 26 February 2016.