In biochemistry, the Lineweaver–Burk plot (or double reciprocal plot) is a graphical representation of the Michaelis–Menten equation of enzyme kinetics, described by Hans Lineweaver and Dean Burk in 1934.[1]
![](http://upload.wikimedia.org/wikipedia/commons/thumb/4/49/LB-plot.jpg/260px-LB-plot.jpg)
The double reciprocal plot distorts the error structure of the data, and is therefore not the most accurate tool for the determination of enzyme kinetic parameters.[2] While the Lineweaver–Burk plot has historically been used for evaluation of the parameters, together with the alternative linear forms of the Michaelis–Menten equation such as the Hanes–Woolf plot or Eadie–Hofstee plot, all linearized forms of the Michaelis–Menten equation should be avoided to calculate the kinetic parameters. Properly weighted non-linear regression methods are significantly more accurate and have become generally accessible with the universal availability of desktop computers.
Definitions
editThe Lineweaver–Burk plot derives from a transformation of the Michaelis–Menten equation,
in which the rate is a function of the substrate concentration and two parameters , the limiting rate, and , the Michaelis constant. Taking reciprocals of both sides of this equation it becomes as follows:
Thus plotting against generates a straight line with ordinate intercept , abscissa intercept and slope .
Applications
editWhen used for determining the type of enzyme inhibition, the Lineweaver–Burk plot can distinguish between competitive, pure non-competitive and uncompetitive inhibitors. The various modes of inhibition can be compared to the uninhibited reaction.
Competitive inhibition
editThe apparent value of is unaffected by competitive inhibitors. Therefore competitive inhibitors have the same intercept on the ordinate as uninhibited enzymes.
Competitive inhibition increases the apparent value of , or lowers substrate affinity. Graphically this can be seen as the inhibited enzyme having a larger intercept on the abscissa.
Pure non-competitive inhibition
editWith pure noncompetitive inhibition the apparent value of is decreased. This can be seen on the Lineweaver–Burk plot as an increased ordinate intercept with no effect on the abscissa intercept , as pure noncompetitive inhibition does not effect substrate affinity.
Mixed inhibition
editPure noncompetitive inhibition is rare, and mixed inhibition is much more common. In mixed inhibition the apparent value of is decreased, and that of is changed—usually increased, meaning that the affinity usually decreases with mixed inhibition.
Cleland recognized that pure noncompetitive inhibition was very rare in practice, occurring mainly with effects of protons and some metal ions, and he redefined noncompetitive to mean mixed.[3] Many authors have followed him in this respect, but not all.
Uncompetitive inhibition
editThe apparent value of decreases with uncompetitive inhibition, with that of . This can be seen on the Lineweaver–Burk plot as an increased intercept on the ordinate with no change in slope.
Substrate affinity increases with uncompetitive inhibition, or lowers the apparent value of . Graphically uncompetitive inhibition can be identified in the plot parallel lines for the different concentrations of inhibitor..
Shortcomings
editThe Lineweaver–Burk plot does a poor job of visualizing experimental error.[4] Specifically, if the errors have uniform standard errors, then those of vary over a very wide range, as can be seen from the following example:
- If then the range of is 0.91–1.11, approximately 20%
- If (same standard deviation) then the range of is 0.0990–0.1001, approximately 1%.
Lineweaver and Burk were aware of this problem, and after investigating the error distribution experimentally,[5] finding a uniform standard deviation in , they consulted the eminent statistician W. Edwards Deming.[6] In the light of his advice they used weights of for fitting their . This aspect of their paper has been almost universally ignored by people who refer to the "method of Lineweaver and Burk."[citation needed]
The values measured at low , and hence large values of lead to points on the far right of the plot and have a large effect on the slope of the line, and thus in particular on the value of .
See also
editReferences
edit- ^ Lineweaver, Hans; Burk, Dean (March 1934). "The Determination of Enzyme Dissociation Constants". Journal of the American Chemical Society. 56 (3): 658–666. doi:10.1021/ja01318a036. ISSN 0002-7863.
- ^ Greco, W. R.; Hakala, M. T. (1979-12-10). "Evaluation of methods for estimating the dissociation constant of tight binding enzyme inhibitors". The Journal of Biological Chemistry. 254 (23): 12104–12109. doi:10.1016/S0021-9258(19)86435-9. ISSN 0021-9258. PMID 500698.
- ^ Cleland, W. W. "The kinetics of enzyme-catalyzed reactions with two or more substrates or products: II. Inhibition: Nomenclature and theory". Biochim. Biophys. Acta. 67 (2): 173–187. doi:10.1016/0926-6569(63)90226-8.
- ^ Dowd, John E.; Riggs, Douglas S. (February 1965). "A Comparison of Estimates of Michaelis-Menten Kinetic Constants from Various Linear Transformations". Journal of Biological Chemistry. 240 (2): 863–869. doi:10.1016/s0021-9258(17)45254-9. ISSN 0021-9258.
- ^ Burk, D. "Nitrogenase". Ergebnisse der Enzymforschung. 3: 23–56.
- ^ Lineweaver H, Burk D, Deming, W E (1934). "The dissociation constant of nitrogen-nitrogenase in Azobacter". J. Amer. Chem. Soc. 56: 225–230. doi:10.1021/ja01316a071.
{{cite journal}}
: CS1 maint: multiple names: authors list (link)
External links
edit- NIH guide, enzyme assay development and analysis