English:
Identifier: flumesfluming87bruc (find matches)
Title: Flumes and fluming
Year: 1914 (1910s)
Authors: Bruce, Eugene Sewell, 1860-1920
Subjects: Flumes
Publisher: Washington, D.C. : U.S. Dept. of Agriculture
Contributing Library: U.S. Department of Agriculture, National Agricultural Library
Digitizing Sponsor: U.S. Department of Agriculture, National Agricultural Library
View Book Page: Book Viewer
About This Book: Catalog Entry
View All Images: All Images From Book
Click here to view book online to see this illustration in context in a browseable online version of this book.
Text Appearing Before Image:
er from beingsplit, broken, and battered on the ends or otherwise injured as muchas when shipped in loose board form. Figure 7 shows the methodmost commonly used in brailing and accoutring material, and a formof clamp. PLANING MILLS SHOULD BE LOCATED AT LOWER END OF FLUME. As a general proposition the planing of sawed lumber which it isnecessary to transport in a flume should be done only after the flum-ing process is completed, since fluming lumber after it is planed usuallyresults in more or less discoloration of the surface, which is also liableto be marred in transit, thus injuring its sale value. SIZE AND CARRYING CAPACITY OF FLUMES FOR DIFFERENT CLASSES OF MATERIAL. The most advisable size of a flume for successfully transportingdifferent classes of material depends on such factors as the grade,volume of water available, length of flume, etc. The class of mate-rial to be handled is always the principal factor to be considered, and 28 BCLLETIX 87, U. S. DEPARTMENT OF AGRICULTURE.
Text Appearing After Image:
FLUMES AND FLUMING. 29 upon this should depend largely the decision of what type or size offlume should be constructed. The capacity of a 24-inch V-shapedflume 10 miles in length, operated on a grade that was neither veryflat nor exceptionally steep, with plenty of water, has been demon-strated as being capable of handling 25,000,000 feet b. m. of railroadcrossties and lumber per annum, under especially favorable conditions. For handling small material, such as railroad crossties, cordwood,mining stulls or props, and loose lumber, a 30-inch V-shaped flume(inside measurement) will usually be found of sufficient capacity formost any requirement, provided the grade is neither too flat nor toosteep. Where either of these exceptions obtain, the size of theflume should preferably be increased to 36 to 40 inches. For a log flume nothing less than a 36-inch V-shaped flume shouldbe built, and a 40 to 60 inch V would be preferable, even for medium-sized logs, if there is a sufficient volume of
Note About Images
Please note that these images are extracted from scanned page images that may have been digitally enhanced for readability - coloration and appearance of these illustrations may not perfectly resemble the original work.